iSMA-B-4O-H

About the product

iSMA-B-4O-H is one of the most easy to setup and versatile IO modules. Compatible with almost any BMS works on either Bacnet or Modbus. It has 4x Digital Outputs (4DO) and can be hand operated. Once you purchase one you will be up and running in minutes and safely use it on any project.

This module is fully compatible with any Modbus or Bacnet system including the following: Tridium Jace3, Jace6, Jace8000 Compatible, Trend IQ3, IQ4 Bacnet IP Compatible, Siemens PX range, Cylon Bacnet controllers, Schneider Electric StruxureWare Bacnet controllers, OSS NeOSS building management controller, Priva Blue ID, Distech EC Bos, DELL EDGE GATEWAY 5000, Compatible with any Honeywell Centraline Hawk, Delta Controls Compatible IO Modules

• 4x Digital Outputs (4DO)
• Relay output (NC/NO) max. 8A, 250V AC/30 VDC

• Cortex-M3

Communication

• Interface RS485 half duplex
• Up to 99 devices on the bus
• Protocols: MODBUS or BACnet
• Baud rate: 2400 to 115200 bps

Power supply

• 24V AC/DC

Housing

• Dimension: 35x110x62 mm.
• Construction: plastic, self-extinguishing (PC/ABS)
• DIN rail mounting (DIN EN 50022 norm)
• Cooling: internal air circulation

Environments

• Operating temperature: -10°C to 50°C
• Storage temperature: -40°C to 85°C
• Relative humidity: 5 to 95%, no condensation
• Ingress Protection Rating: IP40 – for indoor installation

Save time and find out what IO need for your project:

Make sure you get the latest discounts and prices register here:

Documentation & Downloads

iSMA-B-4O-H Installation Instruction

iSMA-B-MINI Datasheet

MINI and MIX Series IO Modbus Manual

	MINI and MIX Series IO BACnet Manual
	BTL_Cert_30201_GlobalCont_iSMABMINII
	BTL_Listing_30201_GlobalCont_iSMABMINII
	iSMA-B-MINI_Declaration_of_Conformity
	Mechanical_drawing iSMA-B-4O-H
	iSMA_Configurator_Release_Notes
	iSMA-B-MINI_RS_Series_FW_Release_Notes

In the DOWNLOAD session you can find:
The ISMA driver for Niagara, which contains the ISMA device Palette
ISMA configurator which is needed for updating firmware and configure modules

For any help please contact our support here